Page 2 of 2

Re: New Georgia Member

Posted: Tue May 22, 2012 7:56 pm
by drew0508
just wondering if they have to be pressed in ill try to get some pics up here soon

Re: New Georgia Member

Posted: Tue May 22, 2012 9:22 pm
by 4g63mightymax
I haven't done them, but I am pretty sure you will need to either press them or beat the hell out of them with hammers.

Re: New Georgia Member

Posted: Wed May 23, 2012 2:01 am
by LethalEthan
if they have metal sleeves on the outside of them, you could burn out the centers, then cut the sleeves with a hacksaw.

Re: New Georgia Member

Posted: Wed May 23, 2012 7:35 am
by 4g63mightymax
LethalEthan wrote:if they have metal sleeves on the outside of them, you could burn out the centers, then cut the sleeves with a hacksaw.
Yeap - Done that a few times. Though sometimes those sleeves are tough to cut!

Re: New Georgia Member

Posted: Wed May 23, 2012 4:14 pm
by drew0508
yeah i really dont want to cut them i guess i will have to get them pressed in

Re: New Georgia Member

Posted: Wed May 23, 2012 4:15 pm
by knuckshaft
I use a air hammer to cut the sleeves

Re: New Georgia Member

Posted: Wed May 23, 2012 6:53 pm
by LethalEthan
press is the best way. Most of the time is spent on set-up but once you get the cup sizes right pressing them out is a breeze.

Re: New Georgia Member

Posted: Wed May 23, 2012 8:30 pm
by drew0508
LethalEthan wrote:press is the best way. Most of the time is spent on set-up but once you get the cup sizes right pressing them out is a breeze.
ok thanks man ill probably take the lower control arms off and take them up to a shop to have them changed out